Digital Control; Eco Mode - Gabarron RF Serie Instrucciones De Instalacion Y Uso Y Cuidado

Key -:
It decreases the
temperature set
point
START / STOP
Press the key to start / stop the heater. Once the heater is started the display will show the room
temperature. When the heater is stopped a small dot in the display will advise that the heater is in stand-by.
To switch it off completely unplug the cable from the supply circuit or operate the double pole switch at the
consumer unit.
SELECTING THE ROOM TEMPERATURE
The digital models RF-F have a built-in ambient thermostat with a sensibility of 0.1ºC. It is possible to set the
room temperature with an accuracy of 0.5ºC.
Set the room temperature by means of the + and – keys. The set point will be shown blinking, then it will be
automatically validated and the display will show the existing room temperature. A small dot will be lit when
the heater is consuming energy.

ECO MODE:

Select the ECO mode by pressing the
be reduced 3ºC.
Key +:
It increases the
temperature set
point.
ECO key:
Press this key to
activate the ECO
mode.
key. The display will show E c o and the room temperature will
MODELS RF-F

DIGITAL CONTROL

16
Digital display:
It shows the temperature
and other messages.
Heating indicator:
This small dot will be lit
when the heater is
consuming energy.
Start / Stop key:
Press this key to start /
stop the heater.
By pressing this key for a
few seconds the keyboard
will be locked. To unlock it
press again this key for a