Maintenance - Truper CEP-12 Manual De Instrucciones

Start Up
For a good finish
• To get a good finish, make small consecutive cuts until
getting the thickness you need.
• Feed the work piece with the wood fibers in the planer
direction to gain a clean work and to prevent the fibers to
get lifted or torn giving wood surface a hairy appearance.
• Feeding the piece in a transversal way can also cause big
splinters to detach giving a very unpleasant appearance.
• Take notice of the piece depth and width, its harness,
humidity, if is straight, direction and structure of grain.
With time and experience, you will gain advantage of
these factors.
• Work with pieces in good repair, without loose knots
and with the least number of firm knots. When working
with a new type of wood, carry out tests in scrap wood
before working the final product.
• Every deep cut shall be made gradually. Move the
depth control hand shank so that the cutter head
descends no more than 1/8" and complete another step.
Repeat this process until getting the desired depth.

Maintenance

WARNING
Disconnect the power cable from the power supply before carrying out adjustments, service or
maintenance in the machine.
• Accumulation of saw dust and other particles may cause the machine working with little precision. Periodic cleansing is
not only advisable but mandatory to gain fine planning.
• Small parts like blocking bars wedges and the cutter head shall be cleaned with a brush and prevent foreign materials
getting stuck and be possible to set them in their positions. Oil lightly those parts.
• Remove resin and other materials accumulated in the feeding rollers. Use a non-flammable solvent.
• Carbon brush replacement. Replace carbon bushes when their size of approximately 1/4" long. Both carbon brushes
shall be replaced always at the same time.
Lubrication
• Lubrication recommended for the rollers' chains,
running with a medium to low operation speed consists
in only keeping the chains clean.
• When there is a considerable accumulation of dust and
dirt, or wood shavings, cover the chain with a light film or
oil. Never apply oil directly on the chain. Oil in excess
may hinder the main purpose of lubrication because it
accelerates the accumulation of dust, wood shavings, etc.,
and get into the chain grooves. This shortens the useful
life of the chain leading to a premature replacement.
• This applies to speed reduction and chain height
adjustment, as well as elevation screws.
• The cutter head bearings are factory lubricated and
sealed. There is no need of further attention.
Recommended
Not
recommended
Service
Servicing the machine shall only be carried out by
certified personnel in a
Service Center. Service and maintenance carried out by
non-certified personnel may result dangerous and can
cause personal injuries and makes the Warranty void.
Authorized
11
ENGLISH