Connecting Dc Power - AB Quality PanelView 300 Micro Instrucciones De Instalación

10 PanelView 300 Micro Terminal

Connecting DC Power

The PV300 Micro terminal connects to a 24V dc power source. The table below
shows the electrical ratings for the DC versions of the terminals. Electronic
circuitry and an internal fuse protect the terminals from reverse polarity and
over-voltage conditions.
Terminal Type
PV300 Micro
PV300 Micro terminal is designed for safe use when installed in a suitably rated
NEMA Type 12, 13, 4X (indoor use only), IP54 or IP65 enclosure.
ATTENTION
!
The input power terminal block on the PanelView 300 Micro is removable and
supports the following wiring types.
Wire Type
Solid
Stranded
41061-156-01(A)
Supply Voltage
11 to 30V dc
(24V dc nominal)
• Do not connect the PanelView terminal to an AC power
source. Connecting to an AC power source will damage the
terminal.
• Use only a Safety Extra Low-Voltage (SELV) power supply
with an output rated between 11 - 30V dc as a power source
for the PanelView 300 Micro. A SELV power supply does
not exceed 42.4V dc.
Wire Size (2-wire maximum per terminal)
#16 to #22 AWG
#18 to #22 AWG
Power Consumption
2.5 Watts maximum
(0.105 Amps @24V dc)