Craftsman ZTS 7500 Manual De Instrucciones página 32

Before
Storage
Before you store your unit for the off=season, read the
Maintenance and Storage instructions in the Safety
Rules section, then perform the following steps:
o Turn the mower blades OFF, set the ground speed
control levers to START / PARK, & remove the key
from the ignition switch,
Check all fluid levels, Check all maintenance items,
o Battery life will be increased if it is removed, put in a
cool, dry place and fully charged about once a
month, if the battery is left in the unit, disconnect the
negative cable,
it is important to prevent gum deposits from forming in
the essential fuel system parts such as the carburetor,
fuel filter, fuel line, and fuel tank during storage, Also,
alcohol blended fuels (called gasohol or using ethanol or
methanol) can attract moisture which leads to the
separation and formation of acids during storage, Acidic
gas can damage the fuel system of an engine while in
storage,
WARNING
Never store the unit (with fuet) in an encJosed,
poorty ventilated structure. FueJ vapors can
traveJ to an ignition source (such as a furnace,
water heater, etc.) and cause an expJosion.
FueJ vapor is aJso toxic to humans and animaJs.
To avoid engine problems use fuel stabilizer, especially
before storage of 30 days or longer,
After
Storage
Before starting the unit after it has been stored:
Check all fluid levels, Check all maintenance items,
o Fill with FRESH fuel,
. After starting, allow the engine to warm before
operating,
NOTE: Specifications are correct at time of printing and are subject to change without notice.
ENGINE:
Make
ModeR
Horsepower*
Displacement
Electrical System
Oil Capacity
Briggs & Stratton
Intek
24 @ 3600 rpm*
44.2 Cu. in (725cc)
12 Volt, !8 amp. Alternator, Battery: 340 CCA
64 Oz. (1.9L)
Fuel Tank
Rear Wheels
Front Wheels
Capacity: 3.25 Gallons (12,3 L)
Tire Size: 18 x 8.8 -8
Inflation Pressure: 10-12 psi (,69-,83 bar)
Tire Size: ! 1 x 4-5
Inflation Press.: 18-20 psi (1,24-1,30 bar)
Make KoMer
Model SV600S Type
Horsepower 20 @ 3600 rpm* Hydraulic Fluid
Displacement 38=4 Cu= in (897 cc) Continuous Torque
Electrical System 12 Volt, 18 amp. Alternator, Battery: 340 CCA Output
OH Capacity 1.6 qt (! .5 L) w filter change Ma×imum Weight
on Axle
Hydro-Gear EZT ZC-AHBB-2A7B-1DPX
20w 80 Premium Engine Oil
115 fL Ibs.
340 Ibs
_Briggs & Stratton Models: The gross po#'er rating for individual gas engine models is labeled in accordance with SAE (Society of
Automotive Engineers) code J1940 (Smafl Engine Power & Torque Rating Procedure), and ratLog performance has been obtaLned
and corrected Lnaccordance with SAE J1995 (Revision 2002-05), Torque values are derived at 3060 RPM; horsepower values are
derived at 3600 RPM, Actual gross engine power #;ql be lower and is affected by, among other thLngs, ambient operating conditions
and engine-to-engine van',sbility, Given both the wide array of products on #;hich engines are placed and the variety of
environmental issues appficable to operating the equipment, the gas engine w_flnot develop the rated gross power #'hen used in a
given piece of power equipment (actual "on-site" or net horsepower), T, h is difference is due to a variet:y of factors including, but not
limited to, accessories (air cleaner, exhaust, charging, coofing, carburetor, fuel pump, etc,), application fimitations, ambient
operating conditions (temperature, humidity, altitude), and engine-to-engine variability, Due to manufacturing and capadty
limitations, Briggs & Stratton may substitute an engine of higher rated power for this Series engine,
32