Led Indicators - FIBARO Home Center 2 Serie Manual De Instrucciones

To start using FIBARO System Home Center 2, please connect the device to power and LAN sockets, as shown below.
1. Unscrew left side panel
HC2 back
2. Take side panel off
3. Connect wires as shown
on figure below
4. Connect Home Center 2
Connect power cable to the mains, and network cable
to LAN socket in your router (Home Center 2 requires an
outside router).

LED Indicators

POWER - power ON
LAN - HC2 connected to Ethernet
INTERNET - HC2 connected to Internet
Z-WAVE - communication within Z-Wave network
RECOVERY - Recovery Mode active
HC2 front
5. Start Home Center 2
Start Home Center 2 with a POWER button and wait approx.
2 minutes for the device to start. Correct connection will be
signalled by diodes 1, 2, 3 (see the glossary below).
POWER
6. Log in to Home Center 2
Go to www.fibaro.com/support, then download and install
FIBARO Finder designated for your operating system. Run
the FIBARO Finder and click „Refresh". List of Home Center
2 available within your local network will appear.
Select Home Center 2 by recognizing it by its serial number
(the number is on the plate on the bottom of the casing) and
click „Connect". After successful connection login page will
appear in the browser.
Choose your language, then log in with default credentials:
Login: admin
Password: admin
7. Download mobile app
LEARN MODE [blinking slowly] - new device being
added to the Z-Wave network
LEARN MODE [blinking] - device being deleted from
the Z-Wave network
LEARN MODE [blinking quickly] - device has been
added/removed
UPDATE - New software version available for
download
SERVICE - Software update in progress
EN
3