Emerson White Rodgers 50E47-843 Instrucciones De Instalación página 4

Control de encendido de superficie caliente universal

Ocultar thumbs

Tabla de contenido

Idiomas disponibles

INSTALL PROGRAM KEY

The control replaces all listed models with the following features:

• 120 volt hot surface ignitor

• remote rod flame sense or direct flame sense through ignitor

• one or three ignition tries

• Seven or four second trial for ignition intervals

• Pre-purge of 30 seconds or less

• 60 second inter-purge time

• 17 or 45 second ignitor warm-up times

Six program keys are provided for different applications. Timings and Retries for each program key are shown in the

Specifications section of this installation manual. Choose the proper program key for the application by using the White-

Rodgers Module Cross Reference (Table 2) or Competitive Module Cross Reference (Table 3) on next page. Install the

selected program key in the slot on the left side of the module (see figure 4 on page 3).

If the module you are replacing is not listed in the White-Rodgers or Competitive tables contact the manufacturer of the

appliance for a recommended replacement or retrofit.

After inserting the proper program key, dispose of the remaining keys to ensure the correct key remains in the module.

Reversal of gas valve leads or open connection to MV1 and MV2 may cause control to lockout. See troubleshooting guide

for remedy.

TABLE 2. White-Rodgers Module Cross Reference for Program Key and Jumper Instruction

MODEL

50E47/50F47-1 THRU -9

50E47/50F47-10 THRU -19

50E47/50F47-20 THRU -29

50E47/50F47-30 THRU -39

50E47/50F47-40 THRU 49

50E47/50F47-50 THRU -59

50E47/50F47-60 THRU 69

50E47/50F47-70 THRU 79

50E47/50F47-101 THRU 109

50E47/50F47-110 THRU 119

50E47/50F47-120 THRU 129

50E47/50F47-130 THRU 139

50E47/50F47-140 THRU 149

50E47/50F47-150 THRU 159

50E47/50F47-160 THRU 169

50E47/50F47-170 THRU 179

50E47/50F47-201 THRU 209

50E47/50F47-210 THRU 219

50E47/50F47-220 THRU 229

50E47/50F47-230 THRU 239

50E47/50F47-240 THRU 249

50E47/50F47-250 THRU 259

50E47/50F47-260 THRU 269

50E47/50F47-270 THRU 279

50E47/50F47-301 THRU 309

50E47/50F47-310 THRU 319

50E47/50F47-320 THRU 329

50E47/50F47-330 THRU 339

50E47/50F47-340 THRU 349

50E47/50F47-350 THRU 359

50E47/50F47-360 THRU 369

50E47/50F47-370 THRU 379

PROGRAM

KEY

INSTRUCTION

A (blue)

E (orange)

B (red)

E (orange)

B (red)

C (green)

F (yellow)

D (violet)

F (yellow)

D (violet)

A (blue)

E (orange)

B (red)

E (orange)

B (red)

C (green)

F (yellow)

D (violet)

F (yellow)

D (violet)

JUMPER

REMOVE

MANUFACTURER

White-Rodgers

Tabla de Contenido

Tabla de contenido

Emerson White Rodgers 50E47-843 Instrucciones De Instalación página 4

Idiomas disponibles

Manuales relacionados para Emerson White Rodgers 50E47-843

Productos relacionados para Emerson White Rodgers 50E47-843

Tabla de contenido