Install The Cabinet Base - Axis T98A-VE Serie Manual De Instrucciones

Page 12

Install the Cabinet Base

1. If required, open drill-outs or cut-outs for extra cable holes in the cabinet base. Markings indi-
cate where these cable holes can be drilled or cut out.
Secure screw (2x)
and screw hole (2x)
2. Hang the cabinet base on the hooks of the mounting plate. Align the lower end of the cabinet
with the alignment indicator for easy access while connecting the cables.
3. Connect the cables, see page 13.
4. Slide the cabinet base to the bottom position and secure it to the mounting plate with the
secure screws (torque 3.0 Nm ±0.2).
AXIS T98A-VE Series Installation Guide
Cabinet base
Drill-out (5x)
Cut-out (5x)
Alignment indicator
Mounting plate
Conduit for cable protection
(not included)
Gasket (5x)