Before Installation - Beeper RW050RF Instalación Y Uso

Cámara de marcha atrás con radiotransmisión
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

1. BEFORE INSTALLATION

Warning
Thank you observe the following before installing the system:
• The system runs on 12V DC (12 V DC). Be sure the polarity of each wire.
• Check before installation if all elements of the car are working properly such as ignition & motor starting, lightings and headlights, turn signal, heating, air conditioning,
power door locks, ... Check after installating all these elements work.
• When you connect the system's ground, it is very important that this ground connection is completely open and stable (no leaks).
• Ensure that every wire passing in tight spaces are protected by adhesive tape to avoid excessive twisting and degradation the plastic wire with a risk of bad contacts.
• Ensure that wire of the system and all the safety accessories are best hidden in the vehicle as possible, never forget you installing a security system.
• Use a digital multimeter to identify the polarity of each son.
• Do not disconnect the battery if the vehicle has a radio code.
• If the vehicle is equipped with an AIRBAG, do not disconnect the vehicle battery.
• Remove the fuse from ceiling when installing the system to prevent battery drain (open).
• The reversing video is an information tool, vehicle safety and those close to it is the responsibility of the driver only, driver must always check if obstacles or people in the
vicinity of the vehicle. Our responsibility can not be engaged in case on collision.
CANBUS VEHICLES
The system is compatible with canbus vehicles. All the information needed to connect wire are on normal polarity (+ or -) of which does not pass coded information (CANBUS,
VAN or other coding). You should absolutely not cut or touch a canbus wire. IN ALL CASES, IT IS USELESS AND RECOMMENDED CUTTING WIRE ORIGINAL VEHICLE. YOU MUST ONLY
MAKE A SPLICE AND RECOVER THE POSITIVE OR NEGATIVE SIGNAL HANDLED BY THIS THREAD. For further information or advice, we urge you to contact our technical department
0 892 690 792 (€ 0.34 / min.)
13

Publicidad

Tabla de contenido
loading

Tabla de contenido