GE Evolve ERS3 Guia De Instalacion página 2

1
UNPACKING
• This luminaire has been properly packed so that no
parts should have been damaged during transit.
• Inspect to confirm.
2
HANDLING
• Damage may occur if luminaire is improperly handled
outside of pack.
• Do not impact or stack luminaire after removal from
packaging.
3
MOUNTING
• Luminaire must be mounted on 2-inch (50.8mm)
diameter mounting arm.
Risk of injury. The luminarie should be mounted so that
prolonged staring into the luminaire at a distance closer than
0.50m is not expected.
Risk of injury. Do not rely on door latch to hold power
module door during installation/maintenance. The door latch
is provided only to aid in the fastening of the captive screw.
4
INSTALLATION
Installation to Mounting Arm:
CAUTION
WARNING
Installation to Mounting Arm for Luminaire with
4 Slip fitter Bolts and One Bottom Door:
• Remove Power door by loosening captive screw,
releasing the door latch and opening door to a
vertical position.
• Disconnect plug which connects top housing wiring
with ballast and plug which connects to LED optical
assembly.
• Now grasp door securely in both hands and open
door further until it comes free from hinges in top
housing.
• This occurs at approximately 35 degrees from vertical
on pole side of hinge. In this position hinge pins will
easily slide upward out of their hinge cradles in top
housing.
• If necessary, adjust 4 pipe clamp bolts such that
opening is slightly larger than mounting pipe diameter.
• The luminaire may be adjusted up or down with
respect to pipe.
• A pad is provided on top of housing for convenient
application of hand level.
• To mount, insert pipe into back of the luminaire until it
hits the leveling steps or stop that sticks down from
the top of housing.
• Hold luminaire approximately level and snug up bolts
(4-5 foot-pounds).