Cleaning And Maintenance - Boneco P500 Manual

CLE ANING AND MAINTENANCE
REPLACING THE FILTER
The filter is worn out if the symbol is illuminated. The
filter must be replaced at this point to continue to ensure
optimal air purification.
The filter must be replaced as soon as possible after the
reminder is displayed but after one year at the latest.
The procedure for replacing the filter corresponds to the
figures on page 14.
1. Replace the filter in accordance with the instructions
on page 14.
2. Hold the button for 5 seconds to the hide the symbol
.
CLEANING THE PRE-FILTER
The pre-filter prevents excessive dust accumulation from
getting inside the BONECO P500.
1. Clean the pre-filter under running water or using a
vacuum cleaner.
2. Allow the pre-filter to dry completely before re-insert-
ing it.
CLEANING THE PARTICLE SENSOR
The particle sensor detects the amount of dirt in the air
in the room by analyzing a passing air stream. Over time,
dirt can accumulate and affect measuring accuracy.
The flap over the particle sensor has to be closed during
operation to ensure the measurement is correct. It should
only be opened to clean the sensor.
1. Wipe the sensor with a damp cotton swab.
2. Dry the sensor with a dry cotton swab.
Do not use alcohol or corrosive cleaning agents for
cleaning.
19
en