4.0 MAINTENANCE
Maintenance operations to be carried periodically are as follows:
- Check that the sensor is properly attached (5-10 mm from the
magnet).
- Make sure that no foreign matter comes between the magnet
and the sensor.
- Store the device in a dry and covered place. If this is not possi-
ble we strongly advise covering it with a cloth, paying especial
attention to the electrical components.
ATTENTION
Store the equipment in a dry and indoor
place. Should this not be possible, it is
RECOMMENDED to cover it with a rubber cloth
paying attention to the electric devices
Sinistra
Left
Links
Gauche
Izquierda
fig. 13
cod. G19502721
USE AND MAINTENANCE
5.0 SPARE PARTS
Orders must be transmitted through our area dealers and should
always include the following indications:
- Type, model and serial number of the machine. These data
are punched on the data plate with which every implement is
equipped.
- Code number of the required spare part. This will be found in
the spare parts catalogue.
- Description of the part and required quantity.
- Table number.
- Means of dispatch. If this item is not indicated, the Manufactu-
rer, while dedicating particular care to this service, shall not be
held responsible for delays in delivery caused by cases of force
majeure.
Transport expenses shall always be at the consignee's charge.
The goods travel at the purchaser's risk and peril even when sold
ex destination.
NOTE: The symbols (Dx) right and (Sx) left, concerning the ma-
chine or single parts of it, are referred, as in the figure, to a rear
view of them (Fig. 13). Exceptions will be indicated.
6.0 ASSEMBLY
Be sure to follow the instructions carefully throughout the
operation.
PAGE 77
Destra
Right
Rechts
Droit
Derecha
ENGLISH
19