Headless Mode; Illumination; Landing; Maintenance - XciteRC Metabo Quadcopter Manual De Intrucciones

Headless mode

The Headless mode is ideal for beginners to fly the model safely. In headless mode, the Quadrocopter always
flys from the pilot's view. No matter how the model is in the air, the front is always away from the pilot, left and
EN
right does not swap when the model is flying towards the pilot.
The Headless mode is activated by pressing the control lever, a beep indicates the function. As long as this
beep appears, the Headless mode is active. Press the control lever again to deactivate the headless mode.

Illumination

Press the control lever to switch the lighting of the Metabo Quadcopter on or off.

Landing:

• Carefully push the left throttle lever rearward. Try to land „smooth" without damaging the Quadrocopter.
• NOTE: if the flight battery runs empty, the Quadrocopter does not respond accurately to your com-
mands, the flight is unstable. In this case land immediately.
• Switch of the Quadrocopter and then the transmitter.
WARNING: the motor of the Metabo Quadcopter may get very hot during operation. Allow to cool
down minimum 20 minutes before the next start to avoid damage. Fire hazard!

Maintenance

To have fun with your model over a long period, occasional service work is required to get your model in good
condition and to minimize wear.
• Remove dirt or dust depending with compressed air or a soft brush after each use. For stubborn dirt, a
harder brush or a toothbrush can be used.
• To clean the body/fuselage no chemical cleaners such as thinners may used, as this damage the plastic
of the body/fuselage. Normally a piece of soft cloth is ok, stubborn dirt can be removed with washing-up
liquid.
• Check the tightness of all screws and tighten if necessary.
• Also check all connections, cables and power battery / rechargeable battery for damage.
• WARNING: Damaged batteries or rechargeable batteries must not be used again and must be
disposed of immediately – fire hazard! Please note the disposal notes at the end of this manual.
• Check the model for worn, broken or jammed parts and gears and repair if necessary.
• WARNING: remove the batteries / rechargeable batteries of the transmitter and model when not in
use – fire hazard!
22
Headless Mode · Illumination · Landing · Maintenance
Press
1 2
LCD Display
L . H
%
E A S Y
Metabo Quadcopter