Lawn Mower - Craftsman 917.378411 Manual Del Usuario

TO ASSEMBLE GRASS CATCHER
1. Put grass catcher frame into grass bag
with rigid part of bag on the bottom.
Make sure the frame handle is outside
of the bag top.
2• Slip vinyl bindings over frame.
NOTE: If vinyl bindings are too stiff, hold
them in warm water for a few minutes• If
bag gets wet, let it dry before using•
_CAUTION: Do not run your lawn mower
without clipping deflector or approved
• grass catcher in place• Never attempt to
operate the lawn mower with the rear
door removed or propped open•
Catcher
frame
handle
ENGINE
ENGINE SPEED
Your engine speed has been factory set.
Do not attempt to increase engine speed
or it may result in personal injury, if you
believe that the engine is running too fast
or too slow, take your lawn mower to a
Sears or other qualified service center for
repair and adjustment.
CARBURETOR
Your carburetor has a non-adjustable
fixed main jet for mixture control. If your
engine does not operate properly due to
suspected carburetor problems, take your
lawn mower to a Sears or other qualified
service center for repair and/or adjust-
ment.
IMPORTANT: Never tamper with the
engine governor, which is factory set for
proper engine speed• Overspeeding the
engine above the factory high speed
setting can be dangerous• If you think the
engine-governed high speed needs
adjusting, contact a Sears or other
qualified service center, which has proper
equipment and experience to make any
necessary adjustments•
Immediately prepare your lawn mower for
storage at the end of the season or if the
unit will not be used for 30 days or more•
LAWN MOWER
When lawn mower is to be stored for a
period of time, clean it thoroughly, remove
all dirt, grease, leaves, etc. Store in a
clean, dry area•
1, Clean entire lawn mower (See
"CLEANING" in the Maintenance
section of this manual)•
2. Lubricate as shown in the Mainte-
nance section of this manual•
3. Be sure that all nuts, bolts, screws,
and pins are securely fastened•
Inspect moving parts for damage,
breakage and wear. Replace if
necessary•
4. Touch up all rusted or chipped paint
surfaces; sand lightly before painting,
15