Before First Use; Turning On The Appliance - Gastrorag DK04B Manual De Instrucciones

Know your percolator

BEFORE FIRST USE

1. Unpack the appliance and place it on a stable stand with a height
of 25-35 inches with a flat horizontal surface.
2. Remove the accessories from the packaging. Remove the
protective film from the stainless steel surfaces.
3. Cleaning and maintenance is carried out in accordance with the
instructions in section "Cleaning and maintenance".

Turning on the appliance

1. Remove the lid. Remove the coffee filter along with its cover and
the water pipe from the appliance body. Fill the body with cold
drinking water. Do not fill the body with hot water! The water level
must not exceed the maximum level. The filling level of the body can
be monitored by means of the measuring markers inside the body of
percolator.
2. Pour 2/5 ounces of medium-ground coffee per 20 fl oz (4 cups)of
water into the coffee filter. For stronger or milder coffee,adjust
amount of coffee to suit your taste. To prevent small coffee grounds
from sifting through the holes in the coffee filter,be sure to use a
grind designed for percolator coffee, or use a coarse grind. Finer
grinds may sift through the holes of the coffee filter! Coffee should
be evenly distributed over the filter.Do not put too much coffee in
the coffee filter. The coffee level should be below the edge of the
coffee filter by at least 4/5 inches.
3. Insert the water pipe into the coffee filter. By holding the top
part of the water pipe, install the coffee filter with the percolation
tube in the body of percolator so that the base of the tube fits
inside the heating element (heating cup).
Turning on the appliance EN
7