Important Safety Instructions; Technical Specifications - Televes T.0X Serie Guía Rápida

PROCESADOR A/D TWIN

Important safety instructions

General installation conditions
• Before handling or connecting the equipment, please read this manual.
• In order to reduce the risk of fi re or electric shock, do not expose the equipment
to rain or moisture.
• No quitar la tapa del equipo sin desconectarlo de la alimentación.
• No obstruir las ranuras de ventilación del equipo.
• Please allow air circulation around the equipment.
• The equipment must not come into contact with water or even be splashed
by liquids. Do not place containers with water on or near the equipment if it is
not adequately protected.
• Do not place the equipment near sources of heat or in excessively moisture
conditions.
• Do not place the equipment where it may be aff ected by strong vibrations or
knocks.
• This symbol indicates that the equipment complies with the
safety requirements for equipment of marked CE.
NOTE: You have a complete User Guide on our website:
www.televes.com.
Links available at the end of this guide.
Technical specifi cations
Input frequency (selec.)
Input level
Down-Converter
Frequency steps
(selec.)
F.I. Bandwidth (selec.)
Output frequency (selec.)
Frequency steps
(selec.)
UP-Converter
Phase noise (typ.)
Output level
Output level regulation
Consumption (typ.)
General
Protection level
* Automatic gain for high level input signals.
These technical specifi cations are defi ned for a maximum ambient temperature of 45 ° C (113 ° F). For higher temperatures forced ventilation is required.
Inputs/Outputs/Connections description
The unit (Fig. 1) is provided with:
1. RF Input (12V/24V/Off )
2. RF Output (input loop-through)
3. RF input (output loop-through)
4. RF output
5. Power BUS connectors
6. Status LED
7. Control BUS connectors
8. Programmer / PC socket
Introduction
It allows to select any channel in the VHF or UHF band (46-862MHz) and
translate it in frequency to any position within these bands.
MHz 46 - 862
dBμV 50 a 80*
Analógico 250
KHz
Digital 166,66 / 125
MHz 6 / 7 / 8
MHz 46 - 862
Analógico 250
KHz
Digital 166,66 / 125
dBc/Hz 80 @10KHz
dBμV 80 ±5
dB > 15
400 @ 24V
mA
450 @ 24V
IP20
IN/OUT Connectors
Input impedance
Input line powering for preamps
(< 50 mA)
Input loop-through gain
Output loop-through losses (typ.)
Return losses (typ.)
IN/OUT Connectors
Output impedance
Spurious level (min.)
Slope regulation
(LNB power OFF)
(LNB power ON)
6
tipo "F" hembra
ohm. 75
V 12 / 24 / OFF
dB 0 ± 3
dB < 1,5
dB > 12
tipo "F" hembra
ohm. 75
dBc 60
dB ±3