Front Panel Features - Numark KMX02 Manual De Inicio Rápido Del Usuario

1.
DJ Mic 1: This section has the gain
and tone controls for the ¼"/XLR
combination mic input.
2.
Mic 2: This section has the gain and
tone controls for Mic 2
3.
Mic 3: This section has the gain and
tone controls for Mic 3
4.
Mic 2&3 Echo: This knob controls the
echo effect amount on microphones 2
and 3.
5.
Mic 2&3 Delay: This knob controls the
delay time of the echo effect on
microphones 2 and 3
6.
Line Faders: Control volume levels in
the mix.
7.
Master Fader - Controls the overall
output level.
8.
Input toggle switch - Selects which
source will be live to that channel based
on what you have connected to the rear
panel input section
9.
Replaceable Crossfader - This slide
fader blends audio between channels 1
and 2. This also switches the video
when using compatible karaoke CD+G
CDs.
Note: The crossfader is user replaceable
in case of failure. Simply unscrew the
two large screws which hold it in place,
lift it out and disconnect it's cable. Re-
attach the new crossfader and screw
the mounting plate back onto the unit -
you're back in business!

FRONT PANEL FEATURES

10.
11.
12.
13.
14.
15.
16.
17.
18.
19.
20. Headphone Jacks – Used to connect
4
Fader Start – Activation allows you to
start the CD players from you
crossfader. Travel from left to right will
start the right CD player and pause the
left CD player
Key Change On/Off – Pressing this
button turns the Key Change function
on and off.
Key – This knob allows you to adjust
the key of the music. Rotating to the
left will result in a lower key (flat),
while rotating to the right will result in
a higher key (sharp).
LED METER - Indicates the Master
output level.
Stereo/Mono toggle - Changes the
Master output between Mono and
Stereo
Master EQ Bass
Master EQ Middle
Master EQ Treble
Channel Cue Selector - Used to route
channel audio to your headphones.
Headphone Level – Adjusts cue
volume.
either 1/8" or 1/4" plugs for audio
monitoring with headphones.