RCA HSFLC1 Serie Guia De Inicio Rapido página 4

MOUNT AND CONNECT THE FLOODLIGHT CAMERA
Turn off power to your floodlight's
1
circuit.
2
Remove your existing floodlight.
Existing Floodlight
Carefully remove your existing floodlight
from its junction box.
Separate the back/base from the
3
floodlight camera.
Floodlight camera, front
Base screws
4
Find the breaker that
controls the circuit for your
floodlight. Turn it off before
you continue installation.
Unscrew the 3 base
screws holding the
floodlight camera to the
base (keep these in a
safe place for later).
Floodlight camera, bottom
3-wire connector
Connect the junction box and
4
floodlight camera 3-wire connector.
Put the ends of each pair into the three wire
nuts, then twist each nut a full turn to finish.
Pull the floodlight
camera completely off
the base.
Turn the floodlight
camera over. Gently
unplug the 3-wire
connector from the
base of the floodlight
camera.
Run the wires from
the 3-wire connector
through the floodlight
camera's base.
Match each color wire
from the floodlight
camera to the same
color from the junction
box (green to green,
white to white, black to
black).