Num'axes CANICOM VOICE 800 Guía De Uso página 19

•
button: beep sound
If you press the button, the receiver collar will emit sound signals. The collar will continue to beep for as long
as the button is pressed. It is possible to use the beep sound in several ways depending on the training method
you use. It can:
−
send a warning to your dog when he is disobedient,
−
draw his attention from distance,
−
serve as a reminder to call him back...
It's very important to always use the beep sounds in the same way in order not to disturb your dog.
•
button: vibrations
If you press the button, the receiver collar will emit vibrations. The collar will continue to vibrate for as long as
the button is pressed.
Vibration can be used in several ways depending on the dressage method you use.
With the vibrations you can:
−
send a warning to your dog when he is disobedient,
−
draw his attention from distance,
−
can be used as a reward when the dog obeys...
It's very important to always use the vibrations in the same way in order not to disturb your dog.
•
−
Touch 1: is used to record or read message N°1
−
Touch 2: is used to record or read message N°2
−
Touch 3: is used to record or read message N°3
−
Touch 4: is used to record or read message N°4
Before any action, you must select the dog for which you want to record messages.
As a reminder: Dog A (collar with black strap) or dog B (collar with yellow strap).
To select the dog for which you want to record messages, briefly press the
the side of your remote control. The letter A or B with the dog pictogram below will appear at the bottom of your
screen.
To save the messages, your collar must be open. Unscrew the 4 screws from the battery cover and push it on the
side. With your finger, hold it on the side for the duration of the recording. Choose short orders that you are used
to using and keep the same intonation as usual. When recording, do not yell or force your voice. Leave the collar
on the table at a minimum distance of about 40 cm.
To save your first message, continuously press the N°1 touch. The LED of the collar will flash in purple and then
switch to fixed purple, release the N°1 touch: you can then speak and record your message. At the end of the
message, briefly press the N°1 touch. Make several recordings to find the optimum recording distance.
Do the same for the following messages (2 to 4).
To listen to your message, briefly press the N°1 touch, the collar will restore your message 1. Do the same
manipulation to listen to the following messages (2 to 4).
To delete a recorded message, 2 options are available to you:
Guide d'utilisation CANICOM Voice 800 – indice A
buttons: messages
➢ Save a message to:
➢ Listen to the message you just saved:
➢
To delete your message:
button with a dog pictogram on
19/60