Dura Heat EWH5500 Instrucciones De Instalación Y El Manual De Propietario página 9

Heater Control Panel:
1. Heater must be properly installed and correctly wired before operation.
2. Turn power supply to heater "ON" at main switch panel.
3. Once the heater has power, the red POWER light will be on.
4. Pushing the red POWER button will turn the heater ON and OFF. When this button is pressed, the
heater and fan will immediately come on and the digital display will flash approximately 5 seconds.
a. If the room temperature is lower than 65°F, the heater will continue to run until the room
temperature reaches 65°F and the heater will then cycle on and off to maintain approximately this room
temperature.
b. If the room temperature is higher than 65°F, the display window will show 65 and flash 5 times
and the heater and fan will stop.
5. Adjusting Power Level: While the unit is ON, push the green mode button once. This will activate the
power selection mode and the red light over the "Fan" or "Heat" will be flashing to show the current
setting. To change from Heat to Fan or Fan to Heat, use the UP or DOWN Arrow buttons. After
approximately 5 seconds the control will then be programmed for the selected output. (For model
EWH5500)
Adjusting Power Level: While the unit is ON, push the green mode button once. This will activate the
power selection mode and the red light over the "L" or "H" will be flashing to show the current setting.
To change from High to Low or Low to High, use the UP or DOWN Arrow buttons. After approximately 5
seconds the control will then be programmed for the selected output. Note: To save energy, the heater
will automatically adjust the power output to low power when room temperature is 2°F below the set
point temperature. (For model EWH9600)
6. Adjusting temperature: While the heater is ON, push the green mode button twice. This will activate
the temperature selection mode and the digital display will flash with the current setting. To adjust, use
the UP or DOWN button until the desired temperature shows on the display. After 5 seconds the display
will change back to displaying the room temperature.
7. Setting Time On Feature: Note: If this feature is not selected, the heater will continue to operate to
maintain the desired temperature. This feature allows the heater to operate for only a predetermined
time. While the heater is ON, push the green mode button three times. This will activate the timer mode
and the display will flash with "0H". By pressing the UP or DOWN Arrow buttons, the display will show
the number of hours the timer will allow the heater to remain on (1H-9H where 1H = 1 hour, and 9H = 9
hours). After 5 seconds, the controller will lock in the setting.
8. Once the controller has been programmed, the heater will cycle on and off to maintain the desired
room temperature. To help extend the life of the heater, after the heater has reached the desired
temperature and the controller turns off the heating element, the fan will continue to operate for
approximately 3 minutes to cool down the heater. This fan delay off feature also occurs when the
heater POWER button is pushed to turn off the heater while it is heating. The fan will continue to run
to cool down the heater.
9. To turn off the heater, push the red POWER button. If the heater is operating, the heater will turn off,
but the fan will continue running for approximately 3 minutes to allow the heater to cool.
OPERATING INSTRUCTIONS