Ryobi VC30A Manual De Utilización página 11

■
Unplug the power plug.
■
After use, empty and dry the tank.
■
Tip: If you want to vacuum up a large quantity of
liquid from a sink or a tank, please don't put the
entire suction nozzle in the liquid; rather leave a
little space so that some air can also be drawn in
along with the liquid.
■
The appliance is equipped with a float switch that
will stop the vacuuming when the tank is full. You
will notice that suction has stopped by the motor
now running faster. In this event, switch the
appliance off and unplug it.
■
Be aware that the full tank can be very heavy. In
this event, place the appliance over a drain and
carefully open the outlet screw. (Fig. 16) The
contents of the tank can now drain out via the
opened outlet.
■
Remove the upper section from the tank and pour
the rest of the liquid into a suitable tank or drain.
Then, you can continue vacuuming after you
have replaced the upper section and drain outlet.
■
After wet vacuuming, switch off the appliance and
unplug it. Empty the container and clean/dry it
inside and outside before putting it away.
After wet vacuuming,
described in the section entitled "Dry Vacuuming"
before you dry vacuum again.
BLOWING: VC30A
Keep bystanders clear from blowing debris. Direct
air discharge only at work area. Do not use
Wet/Dry Vac as a sprayer. Do not direct air at
bystanders.
Wear a dust mask if blowing creates dust that
might be inhaled.
■
Make sure the container is empty before using
as a blower.
■
Remove hose from the vacuum port.
■
Screw on the large end of hose into the blowing
port on the back side of the power head.
(Fig. 19)
■
Fit the desired extension wand and / or nozzle to
the vacuum hose. (Fig. 20)
please proceed as
■
Verify that the switch is in the 'O' OFF position
before plugging the power cord into the outlet.
■
Before turning on the motor, firmly hold loose
end of the hose. Turn the motor on by flipping
the switch to the "I"ON position.
MAINTENANCE
■
Make sure that the appliance is not plugged into
the power mains.
■
Remove the suction hose from the tank.
■
Loosen the clamps and separate the upper
section from the tank.
■
Remove all the dirt and residue from the tank
and the hose.
■
Clean the foam filter by washing it with a mild
detergent.
■
Check the hoses and connections and check the
power cord for any damage.
■
When the foam filter is removed, check the float.
To do this, take the upper section by the handle
and tip it carefully so that the filter basket is
facing upwards. The float should move freely up
and down. (Fig. 21)
When servicing, use only identical replacement
parts. Use of any other parts may create a hazard
or cause product damage.
Always wear safety goggles or safety glasses with
side shields when operating tools. Failure to do so
could result in objects being thrown into your eyes,
resulting in possible serious injury.
Avoid using solvents when cleaning plastic parts.
Most plastics are susceptible to damage from
various types of commercial solvents and may be
damaged by their use. Use clean cloths to remove
dirt, dust, oil, grease, etc.
Do not at any time let brake fluids, gasoline,
petroleum-based products, penetrating oils, etc.,
come in contact with plastic parts. Chemicals can
damage, weaken or destroy plastic which may
result in serious personal injury.
Only the parts shown on the parts list are intended
to be repaired or replaced by the customer. All other
parts should be replaced at a RYOBI Authorized
Service Center.
5