Tru-Test 1 J MkII Manual Del Usuario página 4

Installing the energizer inside
The energizer must be installed inside when
being powered by the mains/line power supply.
Warning!
- Do not use a mains/line power extension
lead.
- All countries except USA and Canada:
Allow 25 mm (1‛) of clear space around
the power adaptor.
To install the energizer inside:
1 Select a suitable installation site. See
Selecting a site for the installation
3.
2 Mount the energizer on a wall. Use the
template printed on the back cover of this
manual, if required.
3 Connect the Fence earth terminal (green)
to the earthing system.
4 Connect the Fence output terminal (red) to
the fence.
5 Connect the energizer to the mains/line
power using the mains/line power
adaptor.
Note:
If the energizer is being installed inside,
it may be powered by a battery, as an
alternative to the mains/line power supply.
4
Installing the energizer outside
The energizer may be installed outside,
powered by a battery.
To install the energizer outside:
1
on page
2
3
4
5
Note:
solar installation by connecting it to a battery
and solar panel(s). For information about solar
installations, refer to the product's website (see
packaging for details).
Warning!
USA/Canada - Refer to
safety instructions for Class 2 power units
(USA/Canada only)
on page 13. All other
countries - Do not power the energizer with
mains/line power if it is being installed
outdoors.
Select a suitable installation site. See
Selecting a site for the installation
3.
Hang the energizer on a fence wire or
mount the energizer on a post. Use the
template printed on the back cover of this
manual, if required.
Connect the Fence earth terminal (green)
to the earthing system.
Connect the Fence output terminal (red) to
the fence.
Connect the energizer to the battery using
the battery leads. Attach the + (red) clip
to the positive terminal of the battery, and
the – (black) clip to its negative terminal.
This energizer may be used as part of a
Important
on page