Corsair T3 RUSH Manual De Instrucciones página 4

ENGLISH
T3 RUSH ASSEMBLY INSTRUCTIONS
3. Place the completed chair base assembly aside.
4. Chair seat assembly.
Remove the four screws from the seat cushion bottom using the M8 Allen key provided.
Using the four screws from the seat cushion bottom, attach the seat control base to the
seat cushion.
FRONT
FRONT
3
T3 RUSH ASSEMBLY INSTRUCTIONS
5. Chair back to seat assembly.
Remove the screws from the seat back
using the M8 Allen key provided.
TIP: Start with the right side of the chair
with the recline mechanism. It is much
easier to start on this side as the mount
point is fixed in place. Do not tighten
the screws down completely until you
have both sides (all four bolts) started
in the seat back.
6. Use the screws taken from the seat back
to attach the seat cushion and the seat
back together. Place the seat assembly
onto the chair base assembly by inserting
the gas lift cylinder into the center hole in
the seat control base.
Make sure the seat assembly is firmly
pressed down into place before using
the chair.
4
ENGLISH