Care And Maintenance; Care And Cleaning Of The Dehumidifier - Emerson DFR29 Manual De Utilización

Removing the collected water
2. Continuous draining
Water can be automatically emptied into a
floor drain by attaching the unit with a water
hose(not included).
Remove the rubber plug from the back drain
hose outlet. Attach a drain hose(ID=13.5mm)
and lead it to the floor drain or a suitable
drainage facility(see Fig.7).
Make sure the hose is secure so there are no
leaks.
Direct the hose toward the drain,making sure
that there are no kinks that will stop the warter
flowing.
Place the end of the hose into the drain and
make sure the end of the hose is level or
down to let the water flow smoothly. Do never
let it up.
Make sure the water hose is lower than the
drain hose outlet.
Select the desired humidity setting and fan
speed on the unit for continuous draining to
start.
NOTE: When the continuous drain feature is
not being used, remove the drain hose from
the outlet and reinstall the rubber plug.

Care and cleaning of the dehumidifier

Turn the dehumidifier off and remove the plug
from the wall outlet before cleaning.
1. Clean the Grille and Case
Use water and a mild detergent. Do not use bleach
or abrasives.
Do not splash water directly onto the main unit. Doing
so may cause an electrical shock, cause the insulation
to deteriorate, or cause the unit to rust.
The air intake and outlet grilles get soiled easily, so use
a vacuum attachment or brush to clean.
2. Clean the bucket
Every few weeks, clean the bucket to prevent growth of mold,
mildew and bacteria. Partially fill the bucket with clean water
and add a little mild detergent. Swish it around in the bucket,
empty and rinse.
NOTE: Do not use a dishwasher to clean the bucket.
After clean, the bucket must be in place and securely
seated for the dehumidifier to operate.

CARE AND MAINTENANCE

Attach the hose
to the drain
hose outlet.
41
remove the rubber
plug
Fig.7