Ega Master 67194 Manual De Instrucciones página 12

The machine must be charged before the first use. Only recharge the machine once it is has been
fully discharged, i.e. the performance clearly decreases. Otherwise the machine may not achieve its full
capacity at the subsequent charge.
Important! Only use the provided battery charger for charging the battery. First place the machine
into the charging slot ,Charging starts automatically.
Remove the machine from the charge after about 5 hours. Always disconnect the charger from the
charger.
Important! Always remove the machine before you change the screw bit to avoid unintentional
starting of the machine. The machine has a quick release chuck feature, simply side the collar forward to
either insert of extract the tip you are using. Let the collar slide back to lock in you tip.
Use the On/Off trigger to start the machine and keep holding it for continuous operation.
To switch the machine off, release the On/Off trigger
The machine has a built in light so as to perform tasks in dark environments. Simply slide the switch
on and off as required when needed. Turn off when not needed so as to save battery life.
Only use tool bits which can be securely fastened in the chuck and for which the bits has been
designed.
Before using the machine check whether the screw-bit is inserted correctly. Avoid over-tightening
screws, otherwise the screw head may be damaged or stripping of the threads may occur.
Set the direction of rotation of the drill to the clockwise direction. Insert the screw-bit into the slot in
the head of the screw. Hold the screw bit perpendicular to the head of the screw, otherwise the screw or
the screw head may be damaged. Press the screw bit against the screw with a constant pressure while
driving in the screw.
When the screw is completely screwed in, hold the machine firmly and release the On/Off trigger,
otherwise the screw or the screw head may be damaged. If the On/Off trigger is not released
immediately a high torque could also damage the drill bit or the drill.
12
INITIAL OPERATION
CHARGING THE MACHINE
INSERTING TOOL BITS
ON/OFF TRIGGER
LIGHT
OPERATION FOR WORKING
SCREW INSERTION