Installation Instructions - Refsta PURO Manual De Instalacion Y Uso

Ocultar thumbs Ver también para PURO:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

ELECTRICAL CONNECTION
The mains power supply must correspond
to the rating indicated on the plate situa-
ted inside the hood. If provided with a plug
connect the hood to a socket in compliance
with current regulations and positioned in
an accessible area, after installation. If it not
fitted with a plug (direct mains connection)
or if the plug is not located in an accessible
area, after installation, apply a double pole
switch in accordance with standards which
assures the complete disconnection of the
mains under conditions relating to over-cur-
rent category III, in accordance with installa-
tion instructions.
Warning! Before re-connecting the hood
circuit to the mains supply and checking
the efficient function, always check that the
mains cable is correctly assembled.
Warning! The hood is provided with a spe-
cial power cable; if the cable is damaged,
request a new one from Technical Service.
OPERATION
Lighting
Minus key. Press this to switch on
OFF
the cooker hood at speed 1. Press it
again to switch it off.
3
Display
Plus key. Press this to switch on the
hood at speed 1. Press it again to
speed up until speed 4.
Timer - this button activates the
timer which will switch off the
aspiration engine after 15 minutes. When
the fan speed is set to 4 the timer activates
automatically. After 7 minutes of activity the
fan will automatically switch to speed 3.
en
es

INSTALLATION INSTRUCTIONS

This hood has been arranged to be installed
above a cook top. It can be used in 2 ways:
EXHAUST MODE: the kitchen vapours are
purified by the metal anti-grease filters and
carried outside through a ducting system.
(Fig. 3A; 3B)
MAINTENANCE
Caution! Before any cleaning or mainte-
nance disconnect the hood from the mains
by removing the plug or disconnecting the
main switch of the dwelling.
Cleaning
The cooker hood should be cleaned regu-
larly (at least with the same frequency with
which you carry out maintenance of the fat
filters) internally and externally. Clean using
the cloth dampened with neutral liquid
detergent. Do not use abrasive products. DO
NOT USE ALCOHOL!
WARNING: Failure to carry out the basic cle-
aning recommendations of the cooker hood
and replacement of the filters may cause fire
risks. Therefore, we recommend observing
these instructions.
The manufacturer declines all respon-
sibility for any damage to the motor or
any fire damage linked to inappropriate
maintenance or failure to observe the
above safety recommendations.
Panel
The panel for perimeter suction should
always be left closed and should only be
opened in case of maintenance interven-
tions (eg cleaning or replacing filters).
Clean the perimeter aspiration panel with
the same frequency as the ant-fats filter,
using a cloth and not too concentrated
liquid detergent. Do not use abrasive sub-
stances. For easy maintenance of the hood,
the perimeter suction panel can be comple-
tely removed.
16
16

Publicidad

Tabla de contenido
loading

Tabla de contenido