• Pressure is not enough or pressure is over the balance:
After long time use, the tool's pressure may be not enough or over its
balance. Therefore we need to adjust the inner adjusting screw.
We have set the standard pressure before supplying the tool, please do
not re-set/increase/decrease the pressure, otherwise the tool may be
damaged. Please use 4mm Hex Key (Allen Key) to adjust the pressure
Clockwise=Increasing Pressure
Counterclockwise=Decreasing Pressure
Take out the protection cap inside the tool.
Adjust the pressure.
After the above steps, please put the protection cap inside the tool back.
Remark: Do not adjust the pressure over or too high.
www.grupotemper.com
KEB-400C
Battery crimper
Instructions manual |
21