Engine Oil; Troubleshooting - Sears Craftsman 917.377562 Manual De Uso

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

ENGINE OIL
Drain oil (with engine warm) and replace with
dean engine elio (See "ENGINE" in the
MaintenarK::e section of this manual),
CYLINDER
• Remove spark plug,
, Pour one ounce (29 ml) of oil through spark
plug hole into cylinder,
• Purl starter handle slowly a few times to
distribute oil,
• Replace with new spark plug_
OTHER
• Do not store gasoline from one season to
another°
• Replace your gasoline can if your can starts
to rust, Rust and/or dirt in your gasoline will
cause problems,
• tf possJ_fe, store your unit indoors and cover
it to give protection from dust and dirt.
o Cover your unit with a suitable protective
cover that does not retain moisture. Do not
use pl_"tic. Plastic cannot breathe which
albws condensation to form and will cause
yourunittorust,
IMPORTANI';
Never cover mower while
engine and exhaust areas are still warm.
CAUTION"
Never store the lawn mower
with gasoline in the tank inside a building
where fumes may reach an open flame or
spark,
Allow the engine to cool before
storing in any enclosure.
TROUBLESHOOTING
CHART
CAUSE
• Dirty air filter.
• Out of fuel,
• Stale fuel,
PROBLEM
Does not start
• Water in fuel,
• Spark ptug wire is
disconnected,
• Bad spark plug,
• Loose blade or broken blade
adapter.
• Control bar in released
position,
• Control bar defective,
CORRECTION
• Clean/replace air filter,
• Flit fuel tanl_
• Drain tank and refill with
fresh clean fuel.
• Drain fuel tank and
carburetor and refill tank
with fresh gasoline.
• Connect wire to plugo
• Replace spark ptug.
• Tighten blade bolt or
replace blade adapter.
• Depress control bar to
handle.
Replace control bar,
16

Publicidad

Tabla de contenido
loading

Tabla de contenido