InfoHub™ LEDS
Status LED lights (A, Figure 3) on the side of the InfoHub™
module can provide valuable information about the operation of
the device.
A
Figure 3
Should you need technical assistance, you may need to provide
the LED status information to technical support (1-833-463-
6482).
Under standard configurations, GPS and Communications LED
lights are enabled using the chart below.
LED Condition Green (GPS)
OFF*
GPS OFF
Slow Blink
Cannot acquire GPS
(1x Per Second)
signal.
Fast Blink
Attempting to
acquire GPS
(4x Per Second)
signal.
3 Blinks + 1
Not Applicable.
Pause
GPS Acquired.
Solid
* Under normal operating conditions, if both GPS &
Communications LEDs are OFF, power to the device has been
lost. The devices are configurable. The modem functionality and
LED status lights can be disabled. In the event the LEDs are not
present when the device is connected to your battery, please
reference www.infohubsp.com or contact technical support to
verify configuration.
Global Position System (GPS) Capabilities
The lnfoHub system contains Global Position System (GPS)
capabilities. The GPS technology provides geo-location
capabilities which can be used to identify the specific location of
a person and/or the equipment. The GPS technology also enables
geo-fencing capabilities which enable triggering responses
when the equipment enters or leaves a particular area and can
be used to identify a person's location relative to predetermined
boundaries. Certain federal and state laws, rules and regulations
may require you to notify employees, or other persons who you
permit to operate or use your equipment, that the equipment
contains the lnfoHub system, and that the lnfoHub system collects
information about their physical location and/or the physical
location of the equipment.
FCC User Information
THIS EQUIPMENT HAS BEEN TESTED AND FOUND TO
COMPLY WITH THE LIMITS FOR A CLASS B DIGITAL DEVICE,
PURSUANT TO PART 15 OF THE FCC RULES.
THESE LIMITS ARE DESIGNED TO PROVIDE REASONABLE
PROTECTION AGAINST HARMFUL INTERFERENCE IN A
RESIDENTIAL INSTALLATION. THIS EQUIPMENT GENERATES,
USES AND CAN RADIATE RADIO FREQUENCY ENERGY, AND
IF NOT INSTALLED AND USED IN ACCORDANCE WITH THE
INSTRUCTIONS, MAY CAUSE HARMFUL INTERFERENCE TO
Orange
RADIO COMMUNICATIONS. HOWEVER, THERE IS NO GUARANTEE
(Communication)
THAT INTERFERENCE WILL NOT OCCUR IN A PARTICULAR
Modem OFF
INSTALLATION. IF THIS EQUIPMENT DOES CAUSE HARMFUL
Cannot acquire
INTERFERENCE TO RADIO OR TELEVISION RECEPTION, WHICH
communication signal.
CAN BE DETERMINED BY TURNING THE EQUIPMENT OFF
AND ON, THE USER IS ENCOURAGED TO TRY TO CORRECT
Attempting to acquire
THE INTERFERENCE BY ONE OR MORE OF THE FOLLOWING
communication signal.
MEASURES:
Registered, but
no inbound
acknowledgment.
Communication
acquired.
IC User Information
THIS DEVICE COMPLIES WITH INDUSTRY CANADA'S LICENCE-
EXEMPT RSSS. OPERATION IS SUBJECT TO THE FOLLOWING
TWO CONDITIONS:
•
•
• REORIENT OR RELOCATE THE RECEIVING ANTENNA.
• INCREASE THE SEPARATION BETWEEN THE EQUIPMENT
AND RECEIVER.
• CONNECT THE EQUIPMENT INTO AN OUTLET ON
A CIRCUIT DIFFERENT FROM THAT TO WHICH THE
RECEIVER IS CONNECTED.
• CONSULT THE DEALER OR AN EXPERIENCED RADIO/TV
TECHNICIAN FOR HELP.
THIS DEVICE MAY NOT CAUSE INTERFERENCE; AND
THIS DEVICE MUST ACCEPT ANY INTERFERENCE,
INCLUDING INTERFERENCE THAT MAY CAUSE UNDESIRED
OPERATION OF THE DEVICE.
7