Setup Instruction - Polygroup SFS350 Manual De Instrucciones

Before assembling your product, please take a few minutes to check the contents and become familiar with all the parts.
WARNING:
CLIMBING HAZZARD! PLEASE PREVENT CHILDREN FROM CLIMBING ON THE FILTER CANISTER TO GAIN ACCESS TO THE POOL.
1. Set up the pool by following all the instructions that came with the pool.
Do not fill with water until the Filter Pump is properly installed. Locate the
Skimmer and Inlet openings on the pool wall
Skimmer Opening
Pool
Inlet
6. Now take out the Pump Motor Assembly
Skimmer Canister securely, insert the Inlet into the bottom of the Canister, and tighten with the Pump Mounting Screws
7
Housing Outlet sticks out from the side as indicated in Fig. 2.
7. Locate the Pool Wall Fitting assembly parts
Fitting . Insert the pool wall fitting with the gasket through the Pool Inlet from the inside of the pool.
t
8. Place the Return Fitting Washer
DO NOT overtighten the Return Fitting Lock Nut or wrinkle the pool wall around the Return Fitting Washer
9. Now apply some petroleum jelly to the threads of the 90° Elbow
Locking Ring onto the wall fitting.
a
10. Get the Return Hose and remove the two Hose Clamps
e
Lubricate the O-Rings on the Volute Housing Outlet (see Fig. 2) and on the 90° Elbow
w
elbow (see Fig. 3). Tighten both of the Hose Clamps
Volute
Housing
Outlet
11
Motor
Pump

SETUP INSTRUCTION

.
;
(see Fig. 2) and lubricate the Volute Housing Inlet o-ring with petroleum jelly (not included). Then hold the
1-5
- . Lubricate the black Fitting Gasket
t a
over the pool wall fitting and then thread the Return Fitting Lock Nut
u
o
from the hardware bag. Loosen the hose clamps and slide them over the ends of the hose.
r
.
r
7
Volute
Housing
Inlet
1-5
6
FIG.2
2. Remove the Skimmer Lock Top
3. Install one Faceplate Gasket
the Skimmer Canister
Skimmer Opening.
NOTE: An extra gasket is included for your convenience.
4. From the inside of Skimmer Opening, align the four large pin holes of
Faceplate with the four pins of Canister, and slot them together.
d
5. Insert the Hex Screws
half turns on each screw. Then continue to tighten the screws alternately, a
few turns at a time, in one direction around the Faceplate.
IMPORTANT: Do not tighten any screw fully. Tightening a screw too much on
one side alone may result in the faceplate developing a leak because the
screws aren't tightened evenly. To ensure a good and even seal, be sure to
make an equal number of turns on the screws, one after the other, until all are
tightened.
Warning! Do NOT overtighten the screws; you just need a watertight seal.
with petroleum jelly and install it over the threads on the Pool Wall
y
and install the elbow into the wall fitting assembly. Install the Return Fitting Diverter
and then install the Hose onto the volute housing outlet and the
o
Pool
Return
Fitting
OWNER'S MANUAL
and take out the parts contained inside.
q
, through the four pins of the canister, onto
s
. Then place the Canister at the outside of
7
into the screw holes. First, make only one and a
f
. Make sure that the Volute
6
onto the fitting until it is hand tight.
i
or Fitting Gasket
u y
29
to
14 20
7
13
13
12
FIG.3
1-5
.
and
p
10
9