Brandt BFL682ZNW Guía De Instalación Y Uso página 31

Reversing the door
The side at which the door opens can
be changed, from the right side (as
supplied) to the left side, if the
installation site requires.
Warning! When reversing the door,
the appliance must not be connected to
the mains. Ensure that the plug is
removed from the mains socket.
Tools you will need:
8mm socket wrench
Cross-shaped screwdriver
Thin-blade screwdriver 8mm wrench
Note: Before you start, lay
refrigerator on its back in order to
gain access to the base. You should
rest it on soft foam packaging or
similar material to avoid damaging the
backboard of the refrigerator.
reverse the door, the following steps
are generally recommended.
1. Stand the refrigerator upright. Open
the door to take out all door racks (to
avoid damaging the racks) and then
close the door.
2. Lift part ① from the top of the
refrigerator body from the right side and
then take down part ③ and part ④ of the
door in the same way. Take down part
② and put it back into the plastic bag.
1
2
the
To
3. Disconnect electrical connector① as
well as electrical connector② and then
take down part③ .
Door racks
Remove the screws ① , loose wire② ,
4.
and remove part③ .
10
①Upper cover
②Upper hinge cover (right)
③Upper cover of upper door
④Corner cover
3
1
2
3