Certificate; Maintenance/Service - Bahco 7455 Guia Del Usuario

CERTIFICATE OF COMPLIANCE
The Torque Wrenches BAHCO 7455 / 7456 are in accordance with
the requirements of:
The test method and the equipment used for the calibration is in
conformity with the afore mentioned norm. International traceability
through calibration laboratories acc. to ISO 9000.
CALIBRATION
Contact your BAHCO sales representative for calibration services.
Equipment Required: A torque source, accurate to 1 % of reading.
Note: To insure specified accuracy:
1. Apply load to the "V" notch on the handle.
2. On flex-ratchet models, the head must be straight.
3. Check calibration every 5000 cycles or annually.
GUARANTEE
The warranty period is 24 months from the date of purchase or date
of in voice and covers faulty parts, materials and defects from poor
workmanship.
If such a case should happen, please contact your local BAHCO
Partner for assistance together with proof of date of purchase of
your tool.

MAINTENANCE/SERVICE

1. The torque wrench's internal mechanism is permanently
lubricated during assembly. Do not attempt to lubricate
the internal mechanism.
2. Clean torque wrench by wiping. Do not immerse.
3. Store torque wrench in protective case at its lowest torque
setting. Do not force handle below lowest setting.
EN 10204
ISO 6789, EN 26789
GB
5