Electrical Connections - Wolf PRO WALL Guia De Instalacion

I NSTAL L AT IO N
Installation
WARNING
Wall framing must be able to support the weight of the
hood and internal blower, if applicable.
Refer to the illustration below for typical wall framing.
1
Additional framing or blocking is required in the
mounting location of the hood.
A wood mounting strip and hardware are provided with
2
the hood. Position the mounting strip on the wall as
shown in the illustration below. Secure the mounting
strip to wall framing and blocking with screws.
Install mounting brackets to the mounting strip. Brackets
3
should be positioned 13 mm above the mounting strip
and as indicated in the chart and illustration below.
Secure the brackets using screws and washers.
M O U N T IN G B R A C K E T L O C AT I ON
76 cm Hood
91 cm Hood
107 cm Hood
122 cm Hood
152 cm Hood 1232 mm
A
MOUNTING BRACKET CENTERS
13
mm
BACK
PANEL
C L
BLOCKING MOUNTING
STRIP
Wall framing (typical).
|
6 English
Aligned with mounting cut-outs on the back panel, lift
4
the hood into position onto the brackets. Secure with
screws and washers through mounting holes. Verify
screws engage the mounting strip. Refer to the illustra-
tions below. If additional support is required, drill supple-
mentary holes through the back panel and secure with
screws.
Make electrical connections.
5
Connect 254 mm round metal ducting to the damper
6
with screws and seal with duct tape.
Reinstall filters.
7
A
597 mm
622 mm
775 mm
927 mm
MOUNTING
CUT-OUTS
Mounting cut-outs. Hood installation.
384
mm

Electrical Connections

WARNING
Before making electrical connections, verify power is
turned off at the service panel.
IMPORTANT NOTE: Refer to installation instructions pro-
vided with each blower assembly for specific mounting and
wiring instructions.
INT E RN AL BL OW E R
Remove the hood's electrical box cover. Insert electrical
1
cable from the service panel into the electrical box. Do
not remove the connector on the orange wire in the box.
Using wire connectors provided, connect black to black,
2
white to white and green/bare wires to the ground screw.
MOUNTING STRIP
Place all wiring connections inside the electrical box and
3
reinstall the cover. Verify all wires are secure and not
pinched between the cover and electrical box.
Plug the blower's power cord into the receptacle inside
4
the hood. Secure excess cord with interior clips. Turn
power on and check operation.
IN -L IN E | R EMO TE B L OW ER
Remove the hood's electrical box cover. Insert electrical
1
cable from the service panel and from the in-line or
remote blower into the electrical box.
Using an appropriate connector, connect the black wire
2
from the blower to the orange wire in the hood.
Connect leads from the cord assembly to leads from the
3
blower. Using wire connectors provided, connect black
to black, white to white and green/bare wires to the
ground screw.
Place all wiring connections inside the electrical box and
4
reinstall the cover. Verify all wires are secure and not
pinched between the cover and electrical box.
Plug the cord assembly into the receptacle inside the
5
hood. Secure excess cord with interior clips. Turn power
on and check operation.