Dismantling; Led Replacement; Technical Assistance Service - TecniWork PODOSCOPIO AP500 Manual Del Usuario

If you have to replace one of the fuses, open the fuse holder placed in the position indicated in the picture on page 17.
Then get out the blown fuse with a suitable instrument and replace it with a T 0,5 A – 5x20 250V fuse.
If you have to replace the power cord, the new one must have the same characteristics and certification of the
original one.
In the case of troubles or needs to replace spare parts, always contact the producer.
WARNING: ALL MAINTENANCE SHOULD BE DONE ONLY AFTER DISCONNECTING
THE DEVICE FROM THE ELECTRICAL MAINS.
LED REPLACEMENT
In case of troubles with LED, please contact the Technical Assistance Service. Do not make direct operations, as
Warranty shall become void.
WARNING: ALL THE OPERATIONS TO REPLACE LED SHOULD BE MADE ONLY BY THE AUTHORIZED
TECHNICAL ASSISTANCE
CAUTION! THE WRONG DISPOSAL OF ELECTRIC AND ELECTRONIC
EQUIPMENT MAY INVOLVE SANCTIONS.
The symbol on the plate of the device indicates the separated collection of electric and electronic equipment. At the
end of life of the device, do not dispose it as mixed solid municipal waste, but dispose it referring to a specific col-
lection centre located in your area or returning it to the distributor, when buying a new device of the same type to
be used with the same functions. This procedure of separated collection of electric and electronic devices is carri-
ed out forecasting a European environmental policy aiming at safeguarding, protecting and improving environment
quality, as well as avoiding potential effects on human health due to the presence of hazardous substances in such
equipment or to an improper use of the same or of parts of the same.
For any inquiry, please call:
FAX: +39 055 8991.801
TECNIWORK S.p.A. - PODOSCOPE AP500
PodoManISTRUZ_A4_x.indd 22

4.2 DISMANTLING

4.3 TECHNICAL ASSISTANCE SERVICE
TEL: +39 055 8991.71
- 22 - doc.cod.IS-05-2 Ed.23/11/16
05/01/17 13:10