( ( 1 1 0 0 ) )
G G A A I I N N
This control, on both the Ultra and Lead channels, controls the input volume level of its
respective channel. Rotating this control clockwise will increase the amount of preamp
distortion and sustain.
( ( 1 1 1 1 ) )
H H I I G G H H
This passive control, on both the Clean and Lead channels, regulates the high frequency
response of its respective channel.
( ( 1 1 2 2 ) )
M M I I D D
This passive control, on both the Clean and Lead channels, regulates the mid frequency
response of its respective channel.
( ( 1 1 3 3 ) )
L L O O W W
This passive control, on both the Clean and Lead channels, regulates the low frequency
response of its respective channel.
( ( 1 1 4 4 ) )
H H I I G G H H G G A A I I N N / / B B R R I I T T I I S S H H / / C C L L A A S S S S I I C C
This three-position switch selects between three distinct EQ and gain voicings on the Lead
channel.
( ( 1 1 5 5 ) )
W W A A R R M M / / M M O O D D E E R R N N / / V V I I N N T T A A G G E E
This three-position switch selects between three distinct EQ voicings on the Clean channel.
( ( 1 1 6 6 ) )
C C H H A A N N N N E E L L A A C C T T I I V V A A T T I I O O N N L L E E D D s s
These indicators signify which channel is active. Ultra channel activation illuminates the red
LED. Lead channel activation illuminates the yellow LED, and Clean channel activation
illuminates the green LED.
( ( 1 1 7 7 ) )
I I N N P P U U T T
This 1/4" jack is designed to accommodate signals from any standard electric guitar.
( ( 1 1 8 8 ) )
C C H H A A N N N N E E L L
This three-position toggle allows selection between the XXL 212 COMBO's three channels.
CHANNEL ACTIVATION LEDs (16) indicate which channel is active. Channel switching can also
be accomplished from the included footswitch. See the FOOTSWITCH section of this manual
for explanation of switch operation. The CHANNEL switch must be set in the ULTRA position in
order for the footswitch to operate properly.
6