Atlantic Colorfalls CC06 Manual De Operación página 7

Follow the instructions below to re-sync the remote control.
1. Unplug the transformer.
2. Hold the E button down (The red indicator lamp on the remote will be lit).
3. While still holding the E button down, plug in the transformer. The Colorfalls will
start blinking.
• If the Colorfalls blinks three times and stops, the remote and control unit are synchronized.
• If the Colorfalls blinks six or more times, it is clearing all codes. Repeat steps 1-3.
LED Light Strip
Figure 4
Maintenance
Atlantic's Color Changing Colorfalls has a removable back plate for easy cleaning
of the interior of the spillway. To clean the interior of the spillway, simply remove
the screws on the back plate and remove the baffle (Figure 4). Remove any large
obstructions that may be present and wipe down the interior with a non-abrasive
cloth. Once finished, install the baffle and re-attach the back plate, making sure that
the gasket is in place to ensure a water-tight seal.
Caution: Be extremely cautious when tightening the screws. It is strongly recom-
mended that you tighten the screws with a hand held screwdriver. Over tightening
the screws could crack the back plate or strip the screw holes. The screws need only
be snug for the gasket to make a seal.
For winterizing, loosen the screws on the back plate to allow excess water to drain.
Once the water is removed from the interior of the spillway, retighten the screws.
Warranty
Colorfalls and all its components carry a one-year limited warranty. This limited
warranty is extended solely to the original purchaser commencing from the date of
the original purchase receipt and is void if any of the following apply:
• The cord has been cut or altered between the Colorfalls and the Control Module.
• The Colorfalls has been misused or abused.
Back Plate
Colorfalls Body
Screws
Inlet Plugs
Baffle
7