Publicidad
Idiomas disponibles
Idiomas disponibles
Fitting the controlled performance loudspeakers
1
Draw around template and mark centre lines if necessary.
181mm (7
")
1/8
Template
3
Connect speaker cables by pushing down on the
terminals and clamping the bare wire in the through
hole.
5
Tighten 3 Tri-Grip screws on the inceiling models or the 6
Tri-Grip screws on the in wall models.
See over tightening
warning.
4
273mm (10
3/4
")
CP CT380 &
CP CT380IDC
Controlled Performance
2
Cut around marked line.
4
Guide speaker into cut out.
6
Fit grilles. They are held in place magnetically and
should 'snap' into place.
Publicidad
