RS Pro RS3000 Serie Manual De Instrucciones página 7

RSJ000/6000-Series User Manual
Mode 2
Continuous Adjustment Mode
CURRENT
'O
P"'Mtold
;
\
OCPON/OFF
PUSH
FINE/COARSE
Mode 3
Remote Control Mode(Programmable Control Mode)
the VOLTAGE and CURRENT adjustment knobs. Then
VOLT A GE
the output of the power supply will be off. At this time,
0\
the CURRENT adjustment knob becomes the output
�
.--. . lll'l lold
knob; push the CURRENT knob and then the output of
LOCICIUNLOCK
the power supply will be ON and OFF accordingly. Push
PUH
and hold the VOLTAGE knob again for 3 seconds and
FINE/COARSE
the VOLTAGE and CURRENT adjustment knobs will be
unlocked .
Power Switch and Output Terminals
0
+
() ()
0
T
In mode 2,rotate the adjustment knobs to adjust the
voltage and current values. The default of the
voltage ini ti al settings is 1 v whi le that of the current
is 1 OO mA. The voltage and current levels can be
changed by pushing the knobs.
Operation of Over Current Protection
press and hold for 3 seconds to start OCP mode, where
the output will be cut off when the output current reaches
the set value. In the OCP mode, rotate this knob to recover
the output. Press and hold for 3 seconds again and then the
OCP function will be closed.
Operation of LOCK
Press and hold the LOCK knob to lock the front panel;
to unlock, press and hold the LOCK knob again.
Push and hold the VOLTAGE knob for 3 seconds to lock
On I Off main power.
-
outputs voltage and current.
Connects the ground (earth ) terminal.
7