Kobalt SGY-CMI Manual Del Usuario página 9

ASSEMBLY INSTRUCTIONS
9. Assemble drum assembly (M) to motor (N) using
motor shaft pin (GG) and cotter pin (JJ).
BE SURE TO SECURE COTTER PIN PROPERLY
BEFORE MIXING ASSEMBLY IS IN MOTION.
HARDWARE USED
JJ 1
Cotter Pin
Motor Shaft Pin 1
GG
Note: The motor shaft may need to be rotated by hand in order to
install the cotter pin.
OPERATING INSTRUCTIONS
Ensure to lock the retaining clip (Position 1) while transporting the mixer.
●
Unlock the retaining clip (Position 2) while dumping drum.
●
Position
1. Before Using The Mixer
Ensure all bolts are tightened.
●
Position the mixer on a level surface.
●
NOTE: Maximum slope is 5 degrees.
Before filling the drum, make sure
●
the mixer can easily empty into a
wheelbarrow.
A "GROUND FAULT INTERRUPTER"
●
protected circuit is recommended for all
outdoor electric devices!
2. Transporting The Mixer
Slide retaining clip over handle to prevent
●
dumping. Always disconnect the power
prior to transporting the mixer.
Mixer can be transported in two ways.
●
Method 1:
a) Turn power to off ("O") position, disconnect
power cord.
b) Ensure drum is empty.
c) Facing front of mixer, grab handle and top
of drum. While holding right wheel down
with with your foot, pull mixer toward yourself.
Be careful not to tip mixer on yourself.
d) Move mixer to desired location.
LL
Position
S1
O/I
13
Black
L
23
White
N
Green
PE
115Vac,60Hz,4.3A
L1 Phase Wire
N Neutral Wire
PE Earth Wire
S1 Electromagnetic Switch
C1 Capacitor
METHOD 1
9
M1
14
Brown
Red
C1
Red
24 AA
Black
T1
A1
White
T1 Thermal Motor Protector
M1 Motor
AA Motor Run Winding
AM Motor Start-up Winding
kobalttools.com
Position
Position
AM