Publicidad
Idiomas disponibles
Idiomas disponibles
US
Important information – please read!
Key to symbols
Warning - risk of electric shock
Warning - risk of water damage
Note, tip or reference
Correct installation
Incorrect installation
On/Off switch
Electric light
Sun (daylight white)
Floor lamp (warm white)
*IMPORTANT SAFETY INSTRUCTIONS
*WARNING ---- This product must be installed by a quali-
fied installer, in accordance with local code and regulations
and according to the instructions in the enclosed installation
manual. Correct installation reduces the risk of fire, electric
shock, burns and injury.
The product is designed for wall mount only.
1. Always disconnect the power before servicing.
2. Only use this appliance for the purpose specified in the
instructions.
3. Do not use this appliance if it does not work properly or if
it has been dropped or damaged. Return the appliance to a
service center for inspection and repair.
4. Only assemble in dry locations.
5. Do not place anything on top of mirror.
General information
– The function, safety and integrity of the product are only
guaranteed if the instructions given in this manual are
adhered to. Non-observance of the safety instructions
could lead to bodily injury and damage to property.
The manufacturer is not liable for damage resulting from
non-observance of the instructions.
– To avoid installation errors and damage to the product,
it is essential that the installation instructions are followed
carefully.
– Besides the information given in this manual, please follow
the relevant general safety and accident prevention
regulations.
– This product left our factory in a condition complying with
all the requirements of technical safety.
– The product must be connected to the power supply
only with the in-wall mains adapter supplied by the
manufacturer with this product.
– Before commencing any cabling work, check that the
cables are at zero voltage. Measures must be taken to
ensure that the cables remain dead for the duration of the
work (e.g. prevent the power supply from being switched
back on).
– The attached documents shall be handed to the user
after installation and functional test.
– Due to its long service life, replacement of the lamp is not
provided for.
– Faulty cords may only be replaced by the manufacturer.
– Before carrying out any drilling work, ensure that no
plumbing or wiring is routed behind the place where you
intend to drill.
– If the mirror is exposed to direct sunlight, there is a risk
of fire occurring due to the mirror focusing the sunlight in
the same way as a magnifying glass. When installing the
mirror, choose a position and angle which do not allow
direct sunlight to fall on the mirror.
– All dimensions are given in inch and (mm).
– Technical changes reserved
Please refer to the attached care and the warranty
card for information on warranty and care.
2 - 12
Publicidad
