Connection To The Electricity Grid; Use - Employment - Amano American SANDERS AVAC12-P Manual De Instrucciones

DANGER:
• To reduce the risk of fire, electric shocks or injury, please read and follow the safety instructions and
warning indications before using. This vacuum cleaner has been designed to be safe when it is used for
cleaning in the specified manner. If damage to electrical or mechanical components is found, the vacuum
cleaner and/or the accessory must be repaired at the relative authorised service centre or else at the
manufacturer before use, in order to prevent further damage to the machine or physical injury to the user.
• Before connecting the machine to the electricity socket, make sure the electrical information on the plate
corresponds to that of the mains supply. The machine must only be powered with alternating current
and voltage equal to that shown on the serial number plate.
• The power supply cable outlet must have an earth connection in compliance with the regulatory standards.
• Before using, check for any damage on the connection cable and on the power plug. If the cable is
damaged, immediately contact a specialist technician for restoring normal operations.
• Connect the machine only to an electrical connection installed by an electrical installer in conformity with
IEC 60364-1.
• Never touch the power plug with wet hands.
• Make sure that the cable to the mains or the extension cable have not been damaged by having been
walked on, crushed, pulled or the like. Protect the cable from heat and from contact with oils or sharp
edges.
• Regularly check that the cable connecting to the mains is not damaged, for example with signs of ageing
or cracks. If there is damage, the cable must be replaced by a specialist TMB srl technician or else by a
technician with similar qualifications before using the machine again.
• Protection against splashes of water and the mechanical strength need to be ensured also after any
replacement of the joints of the power cable or the extension cable.
• Do not clean the machine with a hose or a jet of high pressure water (risk of short-circuit or other electrical
faults).
ATTENTION:
• The procedure causes short-term reduction in voltage.
• In unfavourable grid conditions the other machines could be damaged.
• This damage could occur if the grid impedance is less than 0.15Ω.
DANGER:
• Never use with a damaged cable or plug. When removing from an electrical socket, pull the plug and not
the cable. Do not handle the plug or the vacuum cleaner with wet hands. Deactivate all the controls before
connecting or disconnecting from the electrical socket.
• Do not pull or transport the machine by the cable, do not use the cable as a handle, do not close a door on
the cable, and do not pull the cable around edges or sharp corners. Do not pass the vacuum cleaner over
the cable. Keep the cable away from hot surfaces.
• Be careful when cleaning on stairs.
• The machine must not be used or kept outdoors, in damp conditions or directly exposed to rain.
• The storage temperature must be between -13°F and +131°F.
• Conditions of use: ambient temperature between 32°F and 104°F with a relative humidity between 30 and
95%. The vacuum cleaner has been developed only for dry cleaning and it should not be used or kept
outdoors in moist conditions.

CONNECTION TO THE ELECTRICITY GRID

USE - EMPLOYMENT

3