Technical Data - DOORGATE ROOF EG1012 Manual De Instalación Y Programación

6.2
6.2.1
Problem
6.2.2
The chain is noisy.
6.2.3
The motor does not work.
After setting open and close positions, the
6.2.4
motor does not work.
6.2.5
The door can't be closed.
The wall button works well, but the
6.2.6
transmitter doesn't work.
6.2.7
Transmitter distance is too short.
MAINTENANCE
There is no required maintenance in particular to the exchange. Check at least twice a year if the door is properly
balanced and if the moving parts are in good condition.
NOTE: A door that does not meet the requirements for automation may affect the life of automatism due to incorrect
charges and will void the respective warranty. Check at least twice a year and sensitivity adjustments if necessary. Make
sure that the safety components are fully operational (photocells, etc.).

TECHNICAL DATA

Power input: 230V AC +/- 10% 50Hz
Motor: 24V DC
Courtesy light time: 3 minutes
Lamp: 24V, max. 5W
Operating temperature: -20º~70º
Relative humidity: <90%
Opening and closing force: 600 / 800 / 1000 / 1500N
Reception frequency: 433.92Mhz
Sensitivity: better than 1V for signals received correctly (medium range 30Mts)
Decoding: Rolling Code
INFORMATION FOR THE USER
Once the automation installed, the user should be informed about their mode of operation and all risks arising from its
misuse. You should avoid putting themselves in dangerous situations, such as putting yourself in the path of the door
during operation. Do not allow children to play near the door and hold the Command out of their reach. All interventions,
repairs or revisions must be undertaken by qualified personnel and recorded in a register kept by the user reviews.
In case of failure the user should immediately contact the installer and under no circumstances should you try to repair
the operator and / or the respective accessories.
MANUAL TROLLEY
The drive is equipped with a manual trolley to disengage and allow the engine to move the door manually. This
operation should be done only in case of power failure or malfunction.
FINAL NOTES
This manual is intended solely for qualified personnel to carry out the installation, so no information can ever be
considered useful for the end consumer. No programming or adjustment may be carried out by the end consumer. It is
extremely important that the installer correctly inform the end consumer on how best to operate the respective operator
and accessories, including manual trolley. Tell the owner about the need for regular maintenance, especially the safeties.
EXAMINATION GUIDE
Causes
The chain is too loose.
The socket is not well connect or the fuse
is broken.
The screws of fixing the Hall components
are loose or program mistakes.
Photo beam function works.
No transmitter learning or transmitter
battery is power off.
The transmitter battery is nearly power off.
41
Solution
Adjust nut-M8.
Check the socket or replace the fuse.
Tighten the screws or resetting open and
close.
Cancel the photo beam function, referring
to 5.6.
Code referring to 5.3 or change new
transmitter battery.
Change new battery.
EN