EDM Product KOMA 08704 Manual De Instrucciones página 13

Installing and removing bits (Fig.2)
1. To fit a screwdriver bit, push it into the bit holder until it
locates.
2. To remove a screwdriver bit, pull it straight from the bit
holder.
Make sure it is fully in place before use.
Trigger switch (Fig.3)
1. Start the tool by press the trigger switch
2. Release the switch to stop the machine.
LED working light (Fig. 3)
This tool is equipped with a LED light at the front to work in
darker areas.
Reversible (Fig. 4)
The forward/ reverse rotation control located above the
trigger switch controls the direction of rotation.
For screw driving by using forward rotation, press the rotation
lever on the right position.
For removing screws or release a jammed drill bit by using
reverse rotation, press the rotation lever on the left position to
remove screws.
Adjustable/twistable handle (Fig. 5)
The handle of the screwdriver may be angled or twisted for
ease of control, or a different operating environment.
The handle is fixed in position by a locking switch beside the
power indicator light.
To adjust the handle angle, push and hold this switch forward
and at the same time move the handle to the desire position,
release the switch to lock the handle in the new position.
Note: Do not force the handle, ensure that you are turning it
in the correct direction.
Battery level indicator (Fig. 6)
The tool is equipped with power indicator light.
Press the on/off switch to view the battery charge status.
EN INSTRUCTION MANUAL
SCREWDRIVER 3.6V
Care and Maintenance
This machine requires no special mechanical maintenance
such as greasing the bearings. Do not try to open or
disassemble your drill or feeder to intervene yourself. Do not
open and replace the battery cells. Do not let the drill dead
load. Always use the correct charger recommended.
Improper use may cause risk of electric shock, overheating or
leakage of electrolyte. To protect the batteries from damage,
do not expose to temperatures above 40°C.
Never immerse the machine and do not use detergent,
alcohol, gasoline, etc..
In case of problems or for a deep cleaning, consult the
manufacturer, its service agent or a similarly
qualified person to avoid a hazard.
Environmental Protection
This product is marked with the selective sorting symbol on
waste electrical and electronic equipment. This means that
this product should not be disposed of with household waste
but must be supported by a collection system in accordance
with Directive 2012/19/UE. It will then be recycled or
dismantled to minimize impacts on the environment,
electrical and electronic products are potentially hazardous
to the environment and human health due to the presence
of hazardous substances.
Do not dispose of batteries. Return exhausted batteries to
your local collection or recycling point.
REF. 08704