KTM 54803040000 Instrucciones Para El Armado página 6

A
D
Original
6
You can also combine the various positions (horizontal and vertical, tilt).
Tightening torques:
Nut [5]: 135 Nm
Fixing screw [3]: 3.1 Nm
MAINTENANCE
Check movable components regularly for tight screws and smooth operation and replace any components with original spare parts if
necessary.
Thoroughly clean the footrests regularly.
Spare parts:
Left and right footrest padding 54803040060
Footrest nut 54803040070
Flat head screw 0991040103
Washer 0125150003
Accessory parts:
Crash pads including screws 54803040050
Crash pad screw 0991060202
B C
E F
+5º -5º
ILLUSTRATION A: footrests 6 mm higher
ILLUSTRATION B: same position as the original footrests
ILLUSTRATION C: footrests 6 mm lower
– When you have chosen the desired position of the adapter plate [2],
assemble the joint [1] and adapter plate and tighten the fixing
screw [3].
– Move the footrest [4] back in position and tighten the nut [5].
Tilt
You can determine the tilt of the footrests with the adapter plate [2].
– Loosen the nut [5].
– Remove the footrest [4].
– Loosen the fixing screw [3].
– Turn the adapter plate [2] 90° for one of the three different adjust-
ments:
ILLUSTRATION D: same position as the original footrests
ILLUSTRATION E: footrests tilted by + 5°
ILLUSTRATION F: footrests tilted by - 5°
– Tighten the fixing screw [3] again.
– Move the footrest [4] back in position and tighten the nut [5].