airtec P-04 Serie Instrucciones De Servicio página 4

Operating instructions
54-ATEX-03
for pneumatically operated
(GB)
pneumatic valves of the
Dok.Id.: 177969
Operating instructions for pneumatically operated pneumatic valves of the
P-04, P-05, P-06, P-07, PG-07, P-12, P-34, L-25, L-28, PI-01,
PI-02, PI-03, PN-05, PN-06, PNX-55, PKX-09, PKX-10
These operating instructions address only qualified experts in control and automation
technology with experience in the assembly, installation and commissioning, mainte-
nance and conversion of pneumatic components as well as being familiar with the con-
cept of the types of ignition in areas subject to the risk of explosions.
In the interests of your own safety, please pay attention to the fact that the valves are
only destined to control pneumatic actuators and for use in compliance with their pur-
pose in areas subject to the risk of explosions in Zones 1 and 2 for gases*), fumes*) and
vapour*) or in Zones 21 and 22 for dust*). Therefore, use them as follows:
 In accordance with their purpose,
 In their original state,
 without making your own changes and in technically perfect condition.
The limit values given by AIRTEC for pressures and temperatures must be ob-
served. The national standards, safety regulations and accident prevention regula-
tions must be heeded.
Attention
Read the operating instructions prior to commissioning. In case of improper inter-
vention or if the notes in these operating instructions are ignored, all liability and war-
ranty claims shall lapse.
Caution
Do not remove or cover this type plate / imprint.
In order to perform changes do not dismantle valves. There is a danger of damage
and injury and loss of warranty.
Installation
Mounting:
Medium:
Ambient temperature: -10°C T
For information for working and control pressure, see AIRTEC catalogue.
Compiled:
Name: J. Munz
Date: 14.08.2003
Subject to technical changes.
any type.
Compressed air according to ISO 8573-1: 2010, Class 7:2:4;
-10°C T +50°C and free from aggressive additives.
Medium
+50°C. Alternative the pressure dew point has to be
amb
at least 10°C below deepest occurring ambient temperature.
Tested / clearance
Name: FS
Date: 06.06.2019
Altered:
Name: Mz
Date: 05.06.2019
Rev.-No.15
54-ATEX-03
Page: 4 of 15