Publicidad
Idiomas disponibles
Idiomas disponibles
LED Driver with constant output voltage for the operation of LED
(Electronic switch-type power supply unit)
TYPE: 470571
Protection class 2
1 Technical Data:
Art. No.:
Rated voltage
Constant output voltage
Shared load operation
Open-circuit safety
Short circuit and overload protection
Ambient temperature ta
Housing temperature tc-point
Standard
EMC conformity
Secondary cable
2. Installation Instructions
The installation may only be carried out by an electrical specialist in accordance with international and national standards.
The LED Driver is strictly suited for the use with LED that require a constant voltage of 24VDC.
When connecting the LED, careful attention should be paid to connecting + and – to the right terminals on the LED Driver.
When working on electrical systems, the protection against electric shock is to be ensured by disconnecting the system.
Instal primary and secondary mains intersection-free (RFI protection)
The tc temperature may not be exceeded for any kind of mounting. The devices do not contain any serviceable components and may
not be opened.
3. Important Information
Our LED Drivers are surge-voltage-stable with values above those prescribed by the respective standards. As a protection against high
voltage surges, as they occur e.g. when switching fluorescent lamps and discharge lamps with an inductive ballast, motors (fans, etc.)
and other inductive charges, the load circuits for devices of this kind are to be clearly separated from each other.
!!The LED Driver cannot be regulated via a phase cut-on or cut-off dimmer!!
4. Safety Functions
In case of a short circuit or overload the LED Driver will automatically cut off. It does not have a fuse of the conventional kind. Thus the
load circuit is not separated!
As soon as the defect has been repaired, the LED Driver will automatically cut back in.
5. Heat Dissipation and Heat Transfer
Operation in excess ambient temperature or through external heating will reduce the service life. During the installation process (
particularly into luminaires ), heat dissipation ( heat transfer ) is to be provided through suitable measures. The ambient temperature
and/or tc temperature may not be exceeded at any time. We are not liable for damage resulting from improper use.
Art.-No. 470571
SLV Elektronik GmbH, Daimlerstr. 21-23, 52531 Übach-Palenberg,
Germany, Tel. +49 (0)2451 4833-0
Technical properties subject to modification
Description and Mounting Instructions
CE
09/2010
470571
LPSV16W24
220-240V~ 50-60Hz
24VDC SELV
0-16W
guaranteed
Electronic disconnection with automatic restart
-20°C - +50°C
Max.75°C
EN 61347-1, EN 61347-2-13
EN 61547, EN 55015, EN 61000-3-2, EN 61000-3-3
H03VVH2-F 2x0,75mm²
Publicidad
