Dri-Eaz DefendAir HEPA 500 Manual De Instrucciones página 6

READ AND SAVE THESE INSTRUCTIONS
TROUBLESHOOTING
For any problems not listed below, call your local distributor or contact our Service Department toll free at 888-867-
3235.
PROBLEM
Unit does not operate
Change light illuminated
Blower wheel not turning
SPECIFICATIONS
MODEL
TYPE
VARIABLE CFM
HEIGHT
WIDTH
DEPTH
USE WEIGHT
SHIP WEIGHT
r
141 kinc erkamack Rd. Park Ridge. NJ 07655 Tel. 201-782-1782 Fax. 201-782-1783 Web: www.amgaircorn Email: info@amgaircom
Note: To be assured of true HEPA Oration, change the HEPA filter after
every water damage job. or when the indicator light comes on. whichever occurs
first
When using the DefendAir HERA 500 for remediation:
After every job
• Replace both the filters to prevent cross-contamination.
• Clean the unit thoroughly (vacuum and damp wipe per IICRC 5520, 10.11)
after each job before removing it from the containment area to avoid cross-
contamination. Pay particular attention to the area around the air intake. Let
the unit dry before installing clean filters.
CAUSE
No power to machine
•
Switch not turned on
•
No power to outlet
•
GFCI Tripped
•
Primary filter is full
•
Air intake restricted
•
Obstructed blower
•
Loosen blower wheel set screw
•
CONTROLS
F284
FILTERS
115V
HANDLE
CFM
250-500
HOUSING
24.6' (62.5 CM)
POWER 115V
262' (66.5 CM)
CORD LENGTH
18.2' (46.2 CM)
SAFETY
KG)
44 (19.9
FREQUENCY (HERTZ)
KG)
46 (20.9
Air Marketing Group LLC
SOLUTION
Plug in the unit, check power at outlet
•
Turn on the switch
•
Reset circuit breaker/GFC1
•
Reset circuit breaker/GFCI
•
Replace the filters; refer to Maintenance section
•
Eliminate bends/kinks in ducting, or remove
•
ducting
Remove obstruction
•
Tighten set screw
•
TOUCHPAD
PRE-FILTER
(P/N
13-00199)
HEPA
PRIMARY
P/N
(F321)
ROTOMOLDED
ROTOMOLDED
AMPS
3
FT
25 (7.6 M)
UL LISTED
60
6