Spraying Tips; Spraying Soap - Westinghouse WPX2700H Manual De Usuario

OPERATION
NOZZLE APPLICATION
NOZZLE
1. High Pressure Nozzle
(RED) - higher
pressure & smallest
spray pattern.
NOTE: The red nozzle
can damage surfaces
if it is held too close
for an extended time.
2. High to Medium
Pressure Nozzle
(YELLOW) - High to
medium pressure
with smallest angle
spray pattern.
3. Medium Pressure
Nozzle (GREEN) -
medium pressure
& medium spray
pattern.
4. Low Pressure Nozzle
(WHITE) - lower
pressure & widest
spray pattern.
5. Soap Nozzle (BLACK)
NOTE: Only use
pressure washer safe
soap.
CHANGING THE NOZZLE
1. Push up the trigger lock to the OFF position.
2. Pull the quick coupler toward the spray gun.
3. Push the nozzle into the coupler and push the
coupler away from the spray gun. The nozzle will lock
into place. Tug on the nozzle to verify it is locked in
place.
USE
Use to clean hard,
embedded dirt & grime.
Use on concrete, brick,
driveways, & patios.
Use to clean paint, stain,
mildew, oil, & stuck on
dirt & grime. Use on
wood, decks, home
siding, driveways, &
patios.
For general rinsing ideal for
most all purpose cleaning
such as home siding,
brick patios, wood decks,
driveways and sidewalks,
garage floors, etc.
For delicate rinse for
gentle cleaning of cars/
trucks, boats, RV's patio
furniture, lawn equipment,
etc.
Use to apply soap to
cleaning surfaces in order
to provide a thorough
cleaning.

SPRAYING TIPS

For most cleaning, keep nozzle 8 - 24 in. (20 - 61 cm)
away from cleaning surface.
• Damage may occur to the cleaning surface if you
spray too close, especially with high-pressure
nozzles.
• When beginning to spray, start farther away and
move closer to avoid damage to the surface.
• When cleaning tires, allow at least 6 in. (15 cm)
between a tire and the nozzle.
NOTICE
Do not get any closer than 6 in. (15 cm). Spraying
closer than 6 in. (15 cm) may damage tire.
To relieve system pressure, shut off engine, turn off water
supply and pull gun trigger until water stops flowing.

SPRAYING SOAP

NOTICE
Use only pressure washer-safe soap. Use soaps that are
designed for pressure washers. Use as recommended by
soap manufacturer.
1. Install the soap nozzle (BLACK).
NOTICE
Only use the soap nozzle to apply soap. Using other
nozzles will not apply soap. NEVER use caustic liquid with
pressure washers. Do not route soap siphon hose where it
can contact the muffler while engine is running.
2. Prepare soap solution following manufacturer's
instructions.
3. Place soap siphon hose into soap container.
4. Make sure the garden hose and high-pressure hose
are connected.
NOTICE
All hoses must be connected before starting the engine.
5. Turn on the water supply.
6. Start the engine and squeeze the trigger.
7. Use long, even overlapping stroke to apply soap.
8. Allow 3 - 5 minutes for the soap to soak in before
rinsing. Do not allow the soap to dry on the surface
before rinsing. Reapply soap if necessary to
maintain a wet surface for the soap to soak in.
NOTICE
Clean the soap siphon hose once done.
Westinghouse Outdoor Power Equipment | 15