DeFelsko PosiTest HHD Manual De Instrucciones página 7

The PosiTest HHD powers-up when the power button
pressed. To preserve battery life, it powers-down after
approximately 5 minutes of no activity. Alternatively, select
the menu for immediate power-down. All settings are retained.
1. Review Operational Safety (pg. 2)
2. Assemble the detector for the application to be tested –
"Assembly Instructions" (pg. 5).
3. Properly ground the instrument – "Grounding" (pg. 6).
4. Set the test voltage – "Adjusting the Test Voltage" (pg. 7).
5. Confirm that the detector is in proper working condition –
"Operational Check" (pg. 6).
6. Perform the test – "Instrument Operation" (pg. 9).
STEP 1. Attach the Extension Rod: Press and hold the lock gate
button while inserting the rod. Ensure the anti-rotation tab on the rod
is aligned with the corresponding receptacle on the PosiTest HHD.
Release the lock gate button and ensure the rod is securely
attached.
STEP 2. Attach the Electrode: Loosen the thumb screw on the free
end of the extension rod, attach the required electrode (or adaptor),
and re-tighten the thumb screw.
STEP 3. Attach the Ground Cable: Align the flat side of the cable
connector pin with the alignment mark in the ground cable socket on
the detector, insert fully and rotate the connector clockwise 180° to
secure the cable. Rotate the cable connector 180° counter-
clockwise to unlock and remove the ground cable. (see
"Grounding" pg. 6)
STEP 4. Attach the Shoulder Strap: Clip the strap to the strap
attachment points.
STEP 5. Install the Battery: Loosen the screw on the battery
compartment and remove the cover. Install the battery in the correct
orientation. Replace the cover and secure with the screw.
Quick Start
Assembly Instructions
5
is
from