Atomic G01889W Manual De Instrucciones página 7

STEP 5:
Center P6 Goal Box over the opening in the end panel and attach using pre-drilled pilot holes with H7 Screws as
shown in FIGURE 5.
Center P7 Ball Catcher over the opening in the side panel and attach using pre-drilled pilot holes with H7 Screws
as shown in FIGURE 5.
Make sure the round opening for P8 Ball Return Tube is towards the floor (when table is turned upright).
Repeat for both ends of the table.
Attach P8 Ball Return Tubes between P6 Goal Box and P7 Ball Catcher as shown in FIGURE 5.
All Rights Reserved.
© 2012 Escalade Sports
12 pcs - H7 Phillips Round Head Screw
2 pcs - P6 Goal Box
P8
P6
THIS STEP REQUIRES FOUR OR MORE ADULTS.
VERY CAREFULLY TURN THE TABLE OVER AND SET IT ON
ITS LEGS. BE CAREFUL. THE TABLE IS VERY HEAVY.
PARTS REQUIRED:
2 pcs - P7 Ball Catcher
2 pcs - P8 Ball Return Tube
NOTE: Make sure the round opening
P7 for the ball return tube is towards the
floor (when table is turned upright)
H7
CAUTION:
7
FIGURE 5
For Customer Service Call 1-888-996-2729