GENERAL SAFETY INFORMATION
DO NOT INSTALL IN DIRECT SUNLIGHT. EXCESSIVE SUN OR HEAT MAY CAUSE DISTORTION OR OTHER DAMAGE TO
NON-METALLIC PARTS.
USE ONLY LEAD-FREE SOLDER AND FLUX FOR ALL SWEAT-SOLDER CONNECTIONS, AS REQUIRED BY STATE AND FEDERAL
CODES.
MAXIMUM ALLOWABLE INLET WATER PRESSURE IS 100 PSIG. IF DAYTIME PRESSURE IS OVER 80PSIG, NIGHTTIME PRESSURE
MAY EXCEED THE MAXIMUM. USE A PRESSURE-REDUCING VALVE TO REDUCE THE FLOW IF NECESSARY.
A WATER TEST MUST BE TAKEN BEFORE INSTALLATION OF ANY WATER TREATMENT EQUIPMENT.
DO NOT LOCATE THIS PRODUCT WHERE LEAKING OR FLOODING COULD CAUSE DAMAGE TO THE SURROUNDING PROPERTY.
NOTE: INSPECT FOR SHIPPING DAMAGE AND NOTIFY FREIGHT CARRIER OR STORE WHERE PURCHASED IMMEDIATELY IF
DAMAGE PRESENT.
NOTE: PLEASE READ THE ENTIRE OWNER'S MANUAL AND INSTALLATION INSTRUCTIONS BEFORE INSTALLING YOUR NEW
TANK. SAVE ALL DOCUMENTS AND MANUALS FOR FUTURE REFERENCE.
NOTE: USE PROPER SAFETY EQUIPMENT WHEN INSTALLING.
NOTE: YOU MUST COMPLY WITH ALL PLUMBING CODES.
FAILURE TO FOLLOW THE ABOVE WARNINGS MAY RESULT IN SERIOUS OR FATAL PERSONAL INJURY OR DEATH
AND/OR PERSONAL PROPERTY DAMAGE, AND WILL VOID THE WARRANTY.
CALIFORNIA PROPOSITION 65: THIS PRODUCT CONTAINS A CHEMICAL KNOWN BY THE STATE OF CALIFORNIA TO CAUSE
CANCER AND TO CAUSE BIRTH DEFECTS OR OTHER REPRODUCTIVE HARM. (CALIFORNIA INSTALLER/CONTRACTOR:
CALIFORNIA LAW REQUIRES THAT THIS NOTICE BE GIVEN TO CONSUMER/END USER OF THIS PRODUCT.)
MAXIMUM WORKING PRESSURES: EVERY PROFLO IS AIR TESTED TO 100 PSIG, THE MAXIMUM WORKING PRESSURE FOR
THE PROFLO MODELS LISTED IN THIS MANUAL.
RELIEF VALVE REQUIRED: A RELIEF VALVE SHOULD BE INSTALLED WHICH IS SET TO OPEN AT EXCESSIVE PRESSURES (75
PSIG OR MORE). THIS WILL PROTECT THE PROFLO AND OTHER SYSTEM COMPONENTS SHOULD THE PRESSURE SWITCH
MALFUNCTION AND FAIL TO SHUT THE PUMP OFF. THE RELIEF VALVE SHOULD BE INSTALLED AT THE CONNECTION OF THE
PROFLO TO THE SYSTEM PIPING AND HAVE A DISCHARGE EQUAL TO THE PUMP'S CAPACITY AT 75 PSIG.
6
®